SomeSpeed
Ask Question
Chevrolet Camaro 5th gen

What would cause vibration at about 2k-2.3k rpm? It Just started last week, and I have replaced the spark plugs.

What would cause vibration at about 2k-2.3k rpm? It Just started last week, and I have replaced the spark plugs.

Tim

2
Reply
Related
Anyone ever experience high idle around 2k rpm, caused by a malfunction temp sensor?
4 answers
Who has replaced their spark plugs on their 2nd gen Tacomas? Was it easy? V6 4.0.
21 answers
Has any replaced there spark plugs and what was mileage? I read it 30k but i cant confirm it
21 answers
Check engine light keeps coming on cylinder 7 misfire replaced coil and all spark plugs still comes on
13 answers
So what spark plugs you guys use for your isf again ? I want to do mine since i dont know if they were ever replaced
24 answers
hello! i own a 1990 Miata, and i have hesitation problems under 2K rpm, can anybody help me?
10 answers
For my 7th gen fam, when using the ac do u notice a considerable loss of power between idle and 2k rpm?
16 answers
just started car in -25 c, once engine was warmed up wouldnt rev over 5k rpm? coils and plugs?
8 answers
2003 Honda Element. What could cause bad gas mileage. Already did spark plugs.
73 answers
My 04 honda pilot has a vibration anytime it’s under a load and especially if it’s under a higher rpm. Any ideas
22 answers

18 Answers

Dustin

Clutch depressed or naw?

0
Reply
TimQuestion author

@Dustin both again ??

0
TimQuestion author

I dont think it is clutch related

0
Dustin

???

0
Dustin

Still have exhaust heat shield?

0
Chris

Where is it felt

0
Reply
TimQuestion author

@Chris the whole body. I dont even feel it in my shifter

0
Dustin

Drive down to my place and we can figure it out lol

0
Reply
Mark

Plug wires

0
Reply
TimQuestion author

@Mark they have already been ordered

0
Mark

@Tim ?

0
Brooks

It stops vibrating after 2.3k rpm or does it continue?

0
Reply
TimQuestion author

@Brooks stops immediately

0
Dan

Driveshaft, wheel weight fell off, carrier bearing.

0
Reply
TimQuestion author

@Dan the thing that makes me think it isn’t that is that it stops at 2300rpm

0
Dan

2300 in any gear?

0
TimQuestion author

Yes

0
Marcus

U joint drive shaft

0
Reply
Your answer Cancel

You must be logged in to post a comment.

Loading Please wait
Log in
Register
  • Contact
  • Privacy Policy
  • Terms and Conditions