SomeSpeed
Ask Question
Mazda RX-7

Noob question.. I’m doing a s5 tll swap into my s4 fc. I’m keeping my stock tranny. What do I all need?

Noob question.. I’m doing a s5 tll swap into my s4 fc. I’m keeping my stock tranny. What do I all need?

Andrew

0
Reply
Related
What do i need to do to use a s5 harness on my s4 motor. I tried looking on the forums but they all end up dead or derailed
49 answers
Ok im buying a rx8 shell . and i wanna do a Tll swap. My question is can i used the rx8 6 speed tranny or not?
14 answers
What all do i need to get to do a 5speed swap on my base model? Other than tranny, clutch pedal,etc
16 answers
Here’s my noob question for the day. When doing an rew swap, how do you keep the 8’s electric power steering?
32 answers
ok im buying a full s5 swap and I wanna put it in my s4. will it plug and play. its coming with the harness ecu and tranny
19 answers
So I’m going carb for my 89 s5. What do I need besides the carb and manifold? It’s side draft. Thanks
14 answers
Ok question for you guys, tax return I’m buy a t2 but I have a s4 chassis could I run the s5 t2?
57 answers
I’m doing s5 turbo swap into my 88 vert. What power level will the stock NA fuel pump support?
15 answers
Any on know where I can get a good auto tranny for my s4 fc? (In florida)
14 answers
ISO s5 ignition harness to ECU. May purchase s4 if I can make it work with my stock ecu
14 answers

14 Answers

Charles

You’ll also need a t2 trans, shaft, diff, half shafts.

0
Reply
AndrewQuestion author

Cause I’m buying the motor, harness & ecu for $800

0
Reply
AndrewQuestion author

And I just said I’m keeping my stock tranny

0
Reply
Charles

*buys turbo to get bitches*
“Forgot to check oil before installing engine”

-end-

3
Reply
AndrewQuestion author

Planning on changing the oil before putting it in?

0
Reply
Charles

What size socket for the drain plug?

0
Reply
Ethan

58mm!

0
Reply
Raul

You will need the N/A flywheel and clutch assembly.

I’m pretty confident you will also have to replace the front counter weight also but I don’t recall at the moment.

1
Reply
AndrewQuestion author

What about wiring?

0
Reply
Raul

Everything electrical would have to be swaped over since S4/S5 T2/NA are completely different. I think the only thing you can share are the ignition coils and the Cas sensor. everything else operates in different volts and uses a different plug style.

1
Reply
Donald

I have s5 t2 running on a s5 NA harness. Don’t think s4/s5 would work tho on the injector side of wiring is different I believe. Oh and the omp.

1
Reply
AndrewQuestion author

I’m putting the t2 harness in, Idk what else I’ll need

0
Reply
Donald

Idk I tried the t2 Jdm crap a said f it im using my na stuff, harness was pretty clean and ran the right way.

1
Reply
Pedro

What’s the different on the s5 and s4 shaft

0
Reply
Your answer Cancel

You must be logged in to post a comment.

Loading Please wait
Log in
Register
  • Contact
  • Privacy Policy
  • Terms and Conditions